Tab title not changing hyperterm how to#
Tab title not changing hyperterm update#

Reads incoming electronic pulses on arduino dpin3, saves data to SD card as pulses/sec and the corresponding seconds of time. I had it working just fine while connected to arduino pro, using the following arduino sketch.

Tab title not changing hyperterm how to#

GND) and reconnect it just as you press Enter to run the avrdude command.ģ)Redownloading 'Openlog files', reflashing main.hex - nothing helped.Īnybody have any ideas of how to get it out of that endless loop? You can also disconnect one of the power lines (e.g. The bootloader is only active for a fraction of a second so you need to hit enter and do the reset at the same time. I was wondering if the PP for Camduct would be available for Fusion. The generic PP for Hypertherm in Fusion is drastically different. Wich is the program we use for the Plasma table nesting and Post. But need the program output for the plasma table to be the same as the one Camduct does. Short that pin to a ground – the connector for the 6 pin at the opposite corner is ground, as is the metal case for the micro SD card (which is directly below the reset hole). Im evaluating Fusion to use at work, I use it at home often. OpenLog is now reset to 9600bps.Ģ)reset manually, get a small bit of wire and find the reset connection on the 4 hole SPI interface – it is the square connection hole near the “O” where it says OpenLog on the silkscreen. Now power down OpenLog and remove the RX/GND jumper. You should see the LEDs blink back and forth for 2 seconds, then blink in unison. Tie the RX pin to ground and power up OpenLog. I get the '12<' alright, but if I try to ctrl-z, or hit any button the terminal fills up with endless '12<', non stop.ġ)if you get OpenLog stuck into an unknown baud rate, there is a safety mechanism built-in. We will continue to monitor for changes and once it changes back we will revert the change.

Tab title not changing hyperterm update#

If it detects a change we will set a variable to hidden and update our tab title.

This snippet will listen for visibility changes of the window. I disconnected it(probably shouldn't have) from hyperterm. We will create a small Java Script snippet that we can add to our document ready function. A message appeared stating: 'moving to 'new baud rate' and just stuck there. Navigate through panes with arrows, jump directly to a specific pane with digit, change focus on mouse hover or temporarily maximize a pane. I tried to change the baud rate of my OpenLog while it was connected to Hyperterminal. The title isnt very useful when you only have one tab as you can already see whats happening.Add hyper-hide-title to the plugins list in your /.hyper.js config file.